Updated Nov-2021 Premium NSE7_SDW-6.4 Exam Engine pdf - Download Free Updated 37 Questions [Q15-Q32]

Share

Updated Nov-2021 Premium NSE7_SDW-6.4 Exam Engine pdf - Download Free Updated 37 Questions

Authentic NSE7_SDW-6.4 Dumps With 100% Passing Rate Practice Tests Dumps


Fortinet NSE7_SDW-6.4 Exam Syllabus Topics:

TopicDetails
Topic 1
  • Implement a full or partially meshed redundant VPN infrastructure
  • SD-WAN configuration
Topic 2
  • Configure SD-WAN rules
  • Troubleshoot VPN and ADVPN
Topic 3
  • Central management
  • Configure SD-WAN SLAs
Topic 4
  • Centrally manage an SD-WAN infrastructure from FortiManager
  • Configure basic SD-WAN setup
Topic 5
  • Configure SD-WAN routing
  • SD-WAN troubleshooting
Topic 6
  • Troubleshoot central management problems
  • Troubleshoot SD-WAN

 

NEW QUESTION 15
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology

Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )

  • A. London generates an IKE information message that contains the Toronto public IP address
  • B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN
  • C. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
  • D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

Answer: B,C

 

NEW QUESTION 16
Which three parameters are available to configure SD-WAN rules? (Choose three.)

  • A. Application signatures
  • B. Type of physical link connection
  • C. URL categories
  • D. Source and destination IP address
  • E. Internet service database (ISDB) address object

Answer: B,D,E

 

NEW QUESTION 17
In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )

  • A. Matched traffic failed RPF and was caught by the rule.
  • B. The FIB lookup resolved interface was the SD-WAN member interface
  • C. Traffic has matched none of the FortiGate policy routes
  • D. An absolute SD-WAN rule was defined and matched traffic

Answer: C,D

 

NEW QUESTION 18
Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two )

  • A. FortiGate provides statistics and reading based on historical traffic logs.
  • B. Traffic being controlled by the traffic shaper is under 1 Kbps.
  • C. This traffic shaper drops traffic that exceeds the set limits.
  • D. The debug output shows per-IP shaper values and real-time readings.

Answer: C,D

 

NEW QUESTION 19
Which statement about using BGP routes in SD-WAN is true?

  • A. VPN topologies must be form using only BGP dynamic routing with SD-WAN
  • B. Adding static routes must be enabled on all ADVPN interfaces.
  • C. Dynamic routing protocols can be used only with non-encrypted traffic
  • D. Learned routes can be used as dynamic destinations in SD-WAN rules

Answer: D

 

NEW QUESTION 20
Refer to the exhibit.

Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)

  • A. set load-balance-mode source-ip-based.
  • B. set priority 10.
  • C. set source 100.64.1.1.
  • D. set cost 15.

Answer: A,B

 

NEW QUESTION 21
Refer to exhibits.


Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?

  • A. Port1 became dead 1ecause no traffic was offload through the egress of port1.
  • B. The SLA state of port1 is dead after five unanswered requests by the SLA servers.
  • C. Both SD-WAN member interfaces have used separate SLA targets.
  • D. SD-WAN member interfaces are affected by the SLA state of the inactive interface

Answer: B

 

NEW QUESTION 22
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

  • A. Dead members require manual administrator access to bring them back alive
  • B. SD-WAN interface becomes disabled and port1 becomes the WAN interface
  • C. Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1
  • D. Port2 might become alive when a single response is received from an SLA server

Answer: C

 

NEW QUESTION 23
What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

  • A. FortiGate has obtained a configuration from the platform template in FortiGate cloud.
  • B. The zero-touch provisioning process has completed internally, behind FortiGate.
  • C. A factory reset performed on FortiGate.
  • D. The FortiGate cloud key has not been added to the FortiGate cloud portal.
  • E. FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

Answer: B,D

 

NEW QUESTION 24
Refer to the exhibit.

Based on the output shown in the exhibit, which two criteria on the SD-WAN member configuration can be used to select an outgoing interface in an SD-WAN rule? (Choose two.)

  • A. Set source 100.64.1.1.
  • B. Set cost 15.
  • C. Set priority 10.
  • D. Set load-balance-mode source-ip-ip-based.

Answer: A

 

NEW QUESTION 25
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.
Based on the exhibits, which statement is correct?

  • A. The dead member interface stays unavailable until an administrator manually brings the interface back.
  • B. Port2 needs to wait 500 milliseconds to change the status from alive to dead.
  • C. Check interval is the time to wait before a packet sent by a member interface considered as lost.
  • D. The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.

Answer: D

 

NEW QUESTION 26
Which three parameters are available to configure SD-WAN rules? (Choose three.)

  • A. Type of physical link connection
  • B. URL categories
  • C. Application signatures
  • D. Source and destination IP address
  • E. Internet service database (ISDB) address object

Answer: B,D,E

 

NEW QUESTION 27
Which statement reflects how BGP tags work with SD-WAN rules?

  • A. VPN topologies are formed using only BGP dynamic routing with SD-WAN
  • B. Route tags are used for a BGP community and the SD-WAN rules are assigned the same tag
  • C. BGP tags require that the adding of static routes be enabled on all ADVPN interfaces
  • D. BGP tags match the SD-WAN rule based on the order that these rules were installed.

Answer: D

 

NEW QUESTION 28
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

  • A. The web filter profile must be enabled on the firewall policy
  • B. The shaper mode must be applied per-IP shaper on the traffic shaping policy
  • C. The URL category must be specified on the traffic shaping policy
  • D. The application control profile must be enabled on the firewall policy.

Answer: A

 

NEW QUESTION 29
Refer to the exhibit.

Which two statements about the debug output are correct? (Choose two )

  • A. The debug output shows per-lP shaper values and real-time readings.
  • B. Traffic being controlled by the traffic shaper is under 1 Kbps
  • C. FortiGate provides statistics and readings based on historical traffic logs.
  • D. This traffic shaper drops traffic that exceeds the set limits.

Answer: A,C

 

NEW QUESTION 30
Refer to exhibits.

Exhibit B.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic however inbound traffic is not being evaluated by the shaping policy Based on the exhibit, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic'?

  • A. A new firewall policy must be created and SD-WAN must be selected as the incoming interface.
  • B. The reverse shaper option must be enabled and a traffic shaper must be selected
  • C. The guaranteed-10mbps option must be selected as the reverse shaper option.
  • D. The guaranteed-10mbps option must be selected as the per-IP shaper option

Answer: C

 

NEW QUESTION 31
What would best describe the SD-WAN traffic shaping mode that bases itself on a percentage of available bandwidth?

  • A. Reverse policy shaping mode
  • B. Interface-based shaping mode
  • C. Per-IP shaping mode
  • D. Shared policy shaping mode

Answer: D

 

NEW QUESTION 32
......

Verified Pass NSE7_SDW-6.4 Exam in First Attempt Guaranteed: https://www.braindumpquiz.com/NSE7_SDW-6.4-exam-material.html

Fortinet NSE7_SDW-6.4 Real Exam Questions Guaranteed Updated Dump from BraindumpQuiz : https://drive.google.com/open?id=12sUKGwfurmiY6UyKRIFU-_EKlvZ_05DM