We're so confident of our products that we provide no hassle product exchange.
Cisco Designing Cisco Wireless Networks Sample Questions:
1. An enterprise is using wireless as the main network connectivity for clients. To ensure wireless network availability, two standalone controllers are installed in the head office. APs are connected to the controllers using a round-robin approach to load balance the traffic. After a power cut, the wireless clients disconnect while roaming. An engineer tried eping from the controller but fails. Which protocol needs to be allowed between the networks that the controllers are installed?
A) IP Protocol 87
B) IP Protocol 77
C) IP Protocol 97
D) IP Protocol 67
2. Which issue occurs when wireless access points transmit by using the highest power level in a building that has brick walls?
A) narrowband interference
B) wideband interference
C) reflection
D) hidden node
3. A customer has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity. 5 access points are set to high failover priority and 7 access points are set to critical failover priority. During a failure, not all critical access points failed over to the backup Cisco WLC. Which configuration is the cause of this issue?
A) network ap-priority is set to enable.
B) The critical priority access point count is oversubscribed.
C) network ap-priority is set to disable.
D) The high priority access point is oversubscribed.
4. A network design supports data and voice in 2.4 GHz and 5.0 GHz. The design must support asset tracking without affecting the existing design. Which action must be taken?
A) Increase the transmission power of the existing APs.
B) Add more monitor mode APs to the perimeter of the area.
C) Add more local mode APs to the perimeter of the area.
D) Use more APs grouped closer together.
5. In a FlexConnect deployment, which role does the site tag play?
A) It manages the firewall policies for the site APs.
B) It assigns IP addresses to wireless clients for the site APs.
C) It configures the switch port settings for FlexConnect APs.
D) It defines the roaming domain for FlexConnect APs.
Solutions:
| Question # 1 Answer: C | Question # 2 Answer: D | Question # 3 Answer: B | Question # 4 Answer: B | Question # 5 Answer: D |
By Michell
