[Full-Version] 2021 New BraindumpQuiz NS0-176 PDF Recently Updated Questions
NS0-176 Exam with Guarantee Updated 141 Questions
NetApp NS0-176 Exam Topics:
| Section | Objectives |
|---|---|
| FlexPod Configuration | - Describe how to install and configure the FlexPod components - Describe how to configure neworks in a UCS solution - Describe how to configure SAN boot in a FlexPod solution - Describe knowledge of how to configure a service profile - Demonstrate knowledge of how to configure storage in a FlexPod solution - Demonstrate knowledge of how to configure Cisco Nexus switches |
| Information Gathering for FlexPod Solutions | - Describe the main FlexPod components |
| FlexPod Design | - Describe the storage components supported in FlexPod - Describe the networking components supported in FlexPod - Describe the compute components supported in FlexPod |
| FlexPod Administration | - Demonstrate knowledge of how to administer FlexPod solutions according to FlexPod best practices - Describe FlexPod management applications - Demonstrate knowledge of how to install and upgrade the FlexPod solution |
| FlexPod Troubleshooting | - Demonstrate how to perform FlexPod troubleshooting |
NEW QUESTION 23
Which two are required for single-wire management for Cisco UCS C-Series? (Choose two)
- A. Redundant Nexus 2232PP FEX
- B. UCS Manager 2.1 or higher
- C. 10 GB LOM
- D. VIC 1225
- E. VIC 1240
- F. FI 6200 family only
Answer: B,D
NEW QUESTION 24
Which policy detail should be set if you want a server to be exempt from all power capping?
- A. Create a Power Control Policy select cap and set the priority to 1
- B. Create a Power Control Policy and set Power Capping to No Cap
- C. The UCS Power Cap feature should not be utilized in a FlexPod environment.
- D. Create a Power Group with the appropriate chassis and set the Group Budget Power Cap (W) to 0.
Answer: B
NEW QUESTION 25
Which aggregates should be disabled for data aggregates?
- A. Snapshot copies
- B. FCP
- C. SnapMirror copies
- D. iSCSI
Answer: A
NEW QUESTION 26
When configuring a volume to contain a LUN, which administrative tool automatically applies NetApp recommendations?
- A. Data ONTAP command-line interface
- B. OnCommand System Manager
- C. VMware vSphere
- D. Microsoft SystemCenter
Answer: B
NEW QUESTION 27
Exhibit:
You have FCoE configured between your Nexus 5672UP switches and UCS Fabric Interconnects running in FC end-host mode. You are experiencing disk I/O errors on your VMware FCoE datastore, but the NFS data stores on the same NetApp storage system are not exp eriencing any problems.
Referring to the Nexus output shown in the exhibit, what would cause this problem?
- A. Port flow-control is currently off.
- B. "VL bmap" is hard to set to "off".
- C. The no-drop QoS classes on the Fabric Interconnects are different than those on the Nexus switches.
- D. The FCoE uplinks from the Fabric Interconnects must use the ports on the far right side of the Nexus switches.
Answer: C
NEW QUESTION 28
On a NetApp clustered Data ONTAP cluster, a volume named datastorel resides on an aggregate named node1 aggr1 and is mounted into the namespace at the junction path /esx cluster1/ds1.
A VMware virtual machine file named myhost.vmdk is at the root of the volume datastorel. A volume move operation relocates the datastorel volume to an aggregate named node3 aggr1.
In this scenario, what is the full path to the file myhost.vmdk after the volume move is complete?
- A. /esx_cluster1/datastore1/myhost.vmdk
- B. /esx_cluster1/ds1/myhost.vmdk
- C. node3_aggr3/esx_cluster1/ds1/myhost.vmdk
- D. /vo1/esx_cluster1/ds1/myhost.vmdk
Answer: B
NEW QUESTION 29
You are attempting to establish a cluster peer relationship between two NetApp clusters, but the peering process fails.
What is a cause for this failure?
- A. The cluster management LIF for the cluster cannot communicate with the cluster management LIF for the peer cluster.
- B. The node management LIF on each node cannot communicate with the node management LIF on each node in the peer cluster.
- C. The cluster LIFs on each node cannot communicate with the cluster LIFs on each node in the peer cluster.
- D. The intercluster LIF on each node cannot communicate with the intercluster LIF on each node in the peer cluster.
Answer: D
NEW QUESTION 30
Exhibit:
You are configuring iSCSI boot from SAN on your UCS blades.
Referring to the exhibit, how many paths will there be to the Boot LUN?
- A. 0
- B. 1
- C. 2
- D. 3
Answer: B
NEW QUESTION 31
How should the speed be configured on the Nexus 5548 port connecting to the Nexus 1100-X?
- A. Speed 1G
- B. Speed 1000
- C. Speed 1000000
- D. Speed 10
- E. It should not be configured - the 5548 will auto detect the correct speed
Answer: B
NEW QUESTION 32
Which of the following tools is designed to inventory existing VMware vSphere, Linux, and Microsoft Windows Server versions in a customer environment?
- A. Microsoft Assessment and Planning (MAP) Toolkit
- B. Cisco Resource Comparison Tool
- C. Cisco UCS Sizer for Enterprise Applications
- D. Cisco UCS Central
Answer: A
NEW QUESTION 33
Which two NetApp storage solutions are supported in FlexPod solutions? (Choose two.)
- A. ONTAP Select
- B. NetApp Storage GRID
- C. NetApp E-Series
- D. NetApp AFF
Answer: C,D
NEW QUESTION 34
A customer asks you to configure QoS on a Cisco Nexus 7000 Series switch within a FlexPod solution.
Which three steps are required to accomplish this task? (Choose three.)
- A. Perform a shut/no shut on the affected interfaces.
- B. Attach policies to logical or physical interfaces and VSANs.
- C. Define traffic classes.
- D. Attach policies to logical or physical interfaces and VLANs.
- E. Associate policies and actions with each traffic class.
Answer: B,C,E
NEW QUESTION 35
Which two statements about HA pairs in a NetApp cluster are true? (Choose two.)
- A. HA pairs in the same chassis are not connected to each other through an HA interconnect.
- B. Non-disruptive aggregate relocation can be performed between HA pairs without a takeover and giveback.
- C. In the event of a storage failover, the surviving node provides read/write access to the partner's disks until the failed node becomes available again.
- D. In the event of a storage failover, the surviving node always takes over the partner's data LIFs.
Answer: C,D
NEW QUESTION 36
You are deploying a new virtual machine (VM). Your customer requires that the VM cannot reserve space on the VMFS filesystem, and the VM can only consume blocks when data is written to disk from and within the VM/Guest OS.
Which virtual disk should you create to meet these requirements?
- A. Independent Nonpersistent
- B. Thick Provision Lazy Zeroed
- C. Thick Provision Eager Zeroed
- D. Thin Provision
Answer: D
NEW QUESTION 37
A customer wants to reuse existing networking equipment that was pulled from another data center for a new FlexPod Datacenter solution. They want to know if their switch models are supported.
In this scenario, which two switch models will accomplish this task? (Choose two.)
- A. Cisco Nexus 9396PX
- B. Cisco MDS 9250i
- C. Cisco Catalyst 6504
- D. Cisco Catalyst 9300-48P
Answer: A,B
NEW QUESTION 38
Which three management tools would you use to configure the NetApp storage component in a FlexPod Datacenter solution? (Choose three.)
- A. NetApp OnCommand System Manager
- B. Cisco UCS Central
- C. NetApp OnCommand Perfromance Manager
- D. NetApp Virtual Storage Console (VSC) for VMware Sphere
- E. Cisco UCS Director
Answer: A,B,D
NEW QUESTION 39
How many VEMs can one server have?
- A. unlimited
- B. 0
- C. 1
- D. 2
Answer: D
NEW QUESTION 40
You are asked to increase read performance for a single aggregate; however, there are no PCI-e slots available in the NetApp cluster nodes.
In this scenario, which feature meets these requirements?
- A. Advanced Drive Partitioning
- B. Flash pool
- C. Thin Provisioning
- D. Flash Cache
Answer: B
NEW QUESTION 41
The storage administrator created an export policy for a volume on a NetApp cluster.
The export policy contains a single export rule with the parameters shown below.
- protocol nfs - rorule any
- clientmatch 10.1.16.0/255.255.255.0 - rwrule any
Two hosts attempt to access the volume using the NFS protocol shown below.
- HostA with IP address 10.1.17.37 sends an access request using the NFSv3 protocol
- HostB with IP address 10.1.16.24 sends an access request using the NFSv4 protocol
Which statement about this scenario is true?
- A. HostA will be granted RO/RW access to the volume; HostB's access to the volume will be blocked by the protocol parameter.
- B. HostA's access to the volume will be blocked by the clientmatch parameter; HostB will be granted RO/RW access to the volume.
- C. HostA's access to the volume will be blocked by the clientmatch parameter; HostB's access to the volume will be blocked by the protocol parameter.
- D. HostA's access to the volume will be blocked by the protocol parameter; HostB will be granted RO/RW access to the volume.
Answer: C
NEW QUESTION 42
Which two technologies must be deployed for a Cisco Nexus 9000 ACI design? (Choose two.)
- A. VSM
- B. LACP
- C. spine switch
- D. APIC
Answer: C,D
NEW QUESTION 43
Which two are correct about VSAN configuration within UCS Manager? (Choose two)
- A. In addition to SAN tab, VSANs can be configured under UCSM Server tab as well.
- B. VSAN ID and FCoE VLAN ID have to match.
- C. VSAN can be configured as a global parameter.
- D. VSAN can be configured as fabric interconnect specific.
- E. VSAN IDs 3840-4079 are not available regardless of the Fabric Interconnect mode.
- F. We can delete VSAN 1.
Answer: D,F
NEW QUESTION 44
A Cisco UCS chasis has two power suppliers connected to one PDU and two power supplies connected to another PDU. You would like to protect against the failure of one entire PDU.
In this scenario, which power policy should you configure in UCS Manager?
- A. N+2
- B. redundant
- C. grid
- D. N+1
Answer: C
NEW QUESTION 45
When installing an instance of VMware ESXi on a UCS B-Series server, where should an ISO image be loaded?
- A. Only physical install disks are supported on UCS B-Series servers
- B. The UCS vCenter Plugin must be used
- C. ISO images should not be used
- D. From the UCS Manager select KVM Console, Select the Virtual Media tab, and select Add Image
Answer: D
NEW QUESTION 46
Exhibit:
Which hardware component is shown in the exhibit?
- A. FI
- B. VIC
- C. IOM
- D. FEX
Answer: B
NEW QUESTION 47
......
Latest NS0-176 Pass Guaranteed Exam Dumps Certification Sample Questions: https://www.braindumpquiz.com/NS0-176-exam-material.html