[Dec-2021] Use Real DES-1221 Dumps - 100% Free DES-1221 Exam Dumps [Q25-Q44]

[Dec-2021] Use Real DES-1221 Dumps - 100% Free DES-1221 Exam Dumps

DES-1221 PDF Dumps Exam Questions – Valid DES-1221 Dumps

Sample Questions in Attempting Specialist – Implementation Engineer, PowerStore Solutions Version 1.0

1. When planning rack layout, why should base enclosures be grouped together?

• Power distribution requirements
• Rack weight balance
• Hot aisle requirement
• Ease of cable management

2. What does the remote replication Failover operation do?

• Promotes the destination system to production and resets the RPO synchronization cycle in the protection policy
• Promotes the destination system to production with its replica data consistent to the last successful RPO synchronization state
• Fully synchronizes the source and destination data states and stops the current replication session
• Fully synchronizes the source and destination data states and reverses the replication direction

3. What describes the Import External Storage feature?

• A native network configuration feature of PowerStore that configures external Ethernet switching for PowerStore installation
• A native data migration feature of PowerStore that imports external block storage to PowerStore
• A feature external to PowerStore that orchestrates vMotion movement of virtual machines onto PowerStore X systems
• An external plugin feature for hosts to tune application workload IO on PowerStore NVMe based storage

4. What is the recommended Windows multi-pathing policy for block volumes on a PowerStore array?

• Round-Robin
• FailOver
• Least QueueDepth
• Least Weighted Paths

5. While configuring a Dell switch with PowerStore, what are the recommended license outputs from a show license status command?

• Type: Perpetual, Status: Active
• Status: Perpetual, Type: Open
• Status: Term-Based, Type: Unlimited
• Type: Term-Based, Status: Active

6. A protection policy with snapshot and replication rules is applied to a file system. What is the result?

• Both replication and snapshot rules get applied
• Applying the protection policy to the file system fails
• Snapshot rules get ignored and only replication rules get applied
• Replication rules get ignored and only snapshot rules get applied

7. Which IP addresses are required when adding an appliance to the cluster?

• Management and Storage
• DNS and NTP
• Management and DNS
• Storage and NTP

8. A storage administrator has configured the addition of a VNX2 as a remote system for migration. Which Import External Storage migration feature architectural components are now established?

• Host iSCSI initiators are registered on the VNX2 storage system
• Data path and management control path to the source storage system
• Host Fibre Channel initiators are registered on the VNX2 storage system
• Data path and management control path to the access host

9. What is a way to verify the data path connectivity between a source VNX2 storage system and the PowerStore system when configuring an import session?

• Verify host initiators on PowerStore Manager
• Review Server Manager MPIO properties
• Examine Fibre Channel zoning
• Use the VNX2 SP ping operation

10. What is the correct power up sequence for a PowerStore?

• Base Enclosure Node B, 2. Base Enclosure Node A, 3. Expansion Enclosure
• Base Enclosure, 2. Expansion Enclosure
• Base Enclosure Node A, 2. Base Enclosure Node B, 3. Expansion Enclosure
• Expansion Enclosure, 2. Base Enclosure
• What is the total number of NVRAM devices used in PowerStore 3000?

12. Which API does PowerStore use to communicate with ESXi server during vVols provisioning operation?

• REST
• SOAP
• VASA
• VAAI

13. What is a requirement for the Import External Storage migration feature?

• PowerStore LACP bonded ports are tagged for replication
• PowerPath host-based multipathing software
• PowerStore Global Storage Discovery IP address must be configured
• Direct Fibre Channel connections between storage systems

14. A PowerStore T cluster has 3 appliances. Users are unable to access NAS services. What might be the issue?

• Resource balancer service has failed
• Master appliance is off-line
• NAS appliance failover is incorrectly configured
• Trial license is expired

15. What are the IP requirements for ICW on PowerStore X and PowerStore T models?

• PowerStore T requires five management IP addresses and PowerStore X requires six management IP addresses
• PowerStore T requires four management IP addresses and PowerStore X requires six management IP addresses
• PowerStore T requires seven storage IP addresses and PowerStore X requires three storage IP addresses
• PowerStore T requires three storage IP addresses and PowerStore X requires five storage IP addresses

Understanding functional and technical aspects of Specialist – Implementation Engineer, PowerStore Solutions Version 1.0 PowerStore Configuration (22%)

The following will be discussed in DELL DES-1221 dumps:

• Describe and configure intercluster data migration
• Provision and configure block, file, and VMware storage
• Describe and configure local and remote data protection on PowerStore storage resources
• Configure host and client access to PowerStore block, file, and VMware storage

The appropriate audience includes those who use PowerStore systems to position, design, deploy, maintain and support solutions. To undertake this training, participants are advised to have skillsets that are similar to the prerequisites of the above course. By the end of the program, one will gain mastery in the following objectives:

• Carrying out basic tasks in troubleshooting for PowerStore systems
• Ability to physically install as well as cable systems for PowerStore
• Upgrading hardware as well as software for PowerStore systems
• Administering storage resources as well as services for PowerStore
• Capacity in initializing and deploying systems for PowerStore

The modules that will enable the coming up of such knowledge include physical installation, system initializing, configuration for deployment, and administration, among the rest.

 

NEW QUESTION 25
Which type of network is used for storage migration between appliances?

• A. Inter-node network
• B. Intra-Cluster Data network
• C. Intra-Cluster Management network
• D. Storage network

Answer: C

Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-ntwk-plang/powerstore-t-model- appliance-networks?guid=guid-97a3e988-c1bc-4f51-a445-3af23f19da1b&lang=en-us

 

NEW QUESTION 26
Use the simulator to determine how many logical ports are currently marked for replication on the PowerStore appliance.
Note: It is necessary to close (x) the simulator window before you can select a response to this question.
Simulator:

• A. 0
• B. 1
• C. 2
• D. 3

Answer: B

 

NEW QUESTION 27
Match the CLI command to the appropriate configuration.

Answer:

Explanation:

 

NEW QUESTION 28
How many cables are required for minimum support for PowerStore T Front-End storage connectivity?

• A. 0
• B. 1
• C. 2
• D. 3

Answer: B

 

NEW QUESTION 29
Refer to the Exhibit.

A Network administrator is failing to discover a PowerStore T system using the PowerStore Discovery Utility. What might be the issue?

• A. Port 54 needs to be enabled
• B. Port 54 has not been set to trunk mode
• C. Discovery network uses only native VLAN
• D. Dedicated port needs to be used for discovery network

Answer: D

 

NEW QUESTION 30
1.a.1 What is the maximum number of appliances that can be connected to form a cluster?

• A. 4 in a PowerStore T cluster, 1 in a PowerStore X cluster
• B. 4 in a PowerStore T cluster, 4 in a PowerStore X cluster
• C. 1 in a PowerStore T cluster, 1 in a PowerStore X cluster
• D. 1 in a PowerStore T cluster, 4 in a PowerStore X cluster

Answer: B

 

NEW QUESTION 31
Which ports are recommended for use as the interconnect between the two Dell supplied Data Switches connected to PowerStore?

• A. Two 25 GbE
• B. Four 1 GbE
• C. Two 10 GigE
• D. Two 100 GigE

Answer: D

 

NEW QUESTION 32
1.a.1 What is the maximum number of appliances that can be connected to form a cluster?

• A. 4 in a PowerStore T cluster, 4 in a PowerStore X cluster
• B. 1 in a PowerStore T cluster, 1 in a PowerStore X cluster
• C. 4 in a PowerStore T cluster, 1 in a PowerStore X cluster
• D. 1 in a PowerStore T cluster, 4 in a PowerStore X cluster

Answer: C

Explanation:
Reference:
https://www.delltechnologies.com/en-us/collaterals/unauth/white-papers/products/storage/h18149- dell-emc-powerstore-platform-introduction.pdf

 

NEW QUESTION 33
An administrator receives an alert on a PowerStore Cluster with three appliances:
The appliance A1 is projected to run out of space in 8 days Capacity utilization is above 90 percent Which tools are available to assist the Administrator with a potential resolution?

• A. Thin provision conversion wizard
• B. System Optimization
• C. Assisted Migration
• D. Space reclamation wizard

Answer: C

 

NEW QUESTION 34
When planning rack layout, why should base enclosures be grouped together?

• A. Power distribution requirements
• B. Hot aisle requirement
• C. Rack weight balance
• D. Ease of cable management

Answer: D

 

NEW QUESTION 35
Use the simulator to generate and download logs from all appliances in the PowerStore cluster. When you have finished using the simulator, Click Next.

Answer:

Explanation:
check the answer below in explanation.
Explanation
Below are the exhibits solution for this simulation.

 

NEW QUESTION 36
What is the significance of the warning given when a volume with data services is deleted?

• A. Snapshot is present on the volume
• B. Volume is mapped to a host
• C. Protection policy is configured on the volume
• D. Volume is participating in a migration

Answer: D

Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-cfg-vols/delete-a-volume?
guid=guid-26e8c12d-a3df-4d4d-8012-ae2ef9e53721&lang=en-us

 

NEW QUESTION 37
An administrator received the following alert from PowerStore regarding a previously created NAS server?
Description:
The SMB server of the NAS server PowerStore_NAS_01 is configured to be joined to the domain test.mid, but is currently not joined.
Which setting should the administrator change?

• A. SMB
• B. UDS
• C. LDAP
• D. NTP

Answer: A

Explanation:
Explanation/Reference: https://www.dell.com/support/article/en-pk/sln317202/powerstore-alerts-smb-server-alerts?
lang=en

 

NEW QUESTION 38
A protection policy with snapshot and replication rules is applied to a file system. What is the result?

• A. Replication rules get ignored and only snapshot rules get applied
• B. Applying the protection policy to the file system fails
• C. Both replication and snapshot rules get applied
• D. Snapshot rules get ignored and only replication rules get applied

Answer: C

Explanation:
Explanation/Reference: https://www.dell.com/support/manuals/en-pk/powerstore/pwrstr-protect-data/data-protection-in- powerstore?guid=guid-19c6d0e1-fa20-4fb5-9983-61c17abaf21b&lang=en-us

 

NEW QUESTION 39
A customer is new to PowerStore and asks if there are any differences between the A and B back-end ports. What is the correct response?

• A. "A" ports are output ports and "B" ports are input ports
• B. "A" ports are input ports and "B" ports are output ports
• C. All ports on the base enclosure are output ports
• D. All ports on the base enclosure are input ports

Answer: B

 

NEW QUESTION 40
How many cables are required for minimum support for PowerStore T Front-End storage connectivity?

• A. 0
• B. 1
• C. 2
• D. 3

Answer: B

Explanation:

 

NEW QUESTION 41
How is the VASA provider registered with vSphere when connecting to a PowerStore X system?

• A. VASA is unsupported in PowerStore X models
• B. Automatically added during Initial Configuration
• C. Built into the PowerStore X system code
• D. Manually added from vCenter server using add storage provider option

Answer: D

Explanation:
Explanation/Reference: https://www.delltechnologies.com/en-ca/collaterals/unauth/white-papers/products/storage/ h18116-dell-emc-powerstore-vmware-vsphere-best-practices.pdf (17)

 

NEW QUESTION 42
Use the PowerStore Manager simulator to configure the BaseEnclosure-NodeA-IoModule1-FEport0 as a replication port. When you have finished using the simulator, Click Next.

Answer:

Explanation:
Below are the exhibits solution for this simulation.

 

NEW QUESTION 43
Refer to the Exhibit.

What happens to the parent resource of thin clone 3 if thin clone 2 is deleted?

• A. Thin clone 3 has an empty parent
• B. Thin clone 1 becomes parent
• C. Thin clone 3 becomes parent
• D. Snapshot 3 becomes the parent

Answer: A

 

NEW QUESTION 44
......

Ultimate DES-1221 Guide to Prepare Free Latest EMC Practice Tests Dumps: https://www.braindumpquiz.com/DES-1221-exam-material.html

Get Top-Rated EMC DES-1221 Exam Dumps Now: https://drive.google.com/open?id=1gCmvevrq6m4Uhbs78NhPtZ1dE0ra2JxI