We're so confident of our products that we provide no hassle product exchange.
BICSI Installer 2 - Copper Sample Questions:
1. Which of the refers to a rule or set of rules intended to endure safety during the installation and use of materials, components, fixtures, systems, premises and related subjects?
A) Regulation
B) Standard
C) Code
D) Directive
2. Which of the following indicates a critical reason to avoid over-cinching cable bundles with tie-wraps?
A) It can increase the length of the cable runs by 15-20%
B) It can deform the cable jacket and alter pair geometry, leading to degraded performance
C) It may cause increased EMI within each twisted pair
D) It may leave excessive slack in the horizontal runs
3. When bonding a shielded twisted-pair cable system, which of the following must be ensured to comply with proper grounding and bonding practices?
A) Only the outer jacket is stripped back to expose the shield at the connector
B) The cable shield is bonded to a non-conductive anchor to prevent ground loops
C) The shield is folded back outside of the connector for easy visual inspection
D) The drain wire or shield foil is securely bonded to the connecting hardware or patch panel that is connected to the TGB/TMGB
4. When routing conduits through a fire-rated floor assembly, which principle BEST ensures compliance with fire code requirements?
A) Placing a service loop inside the conduit above the floor
B) Installing a second parallel conduit for redundancy
C) Oversizing the conduit to reduce cable friction
D) Filling any gap around the conduit with an approved firestop system
5. Which topology uses a linear configuration that places all network devices on one length of cable?
A) Bus
B) Ring
C) Star
Solutions:
| Question # 1 Answer: C | Question # 2 Answer: B | Question # 3 Answer: D | Question # 4 Answer: D | Question # 5 Answer: A |
By Raymond
