HP Support and Service HP StoreOnce Solutions Sample Questions:
1. A customer is attempting replication between HP StoreOnce G3 devices. The target has been licensed, but replication cannot be established. What should you check when troubleshooting?
A) Replication is now only supported by using Catalyst.
B) Replication between HP StoreOnce devices requires use of Fibre Channel.
C) The IP ports associated with replication cannot be blocked by a firewall.
D) The interfaces used for replication must all be in the same VLAN.
2. A customer is experiencing unreliable iSCSI connections to an HP StoreOnce Backup System. What do you have to examine?
A) Block size of the iSCSI target device
B) MTU size of all devices in the data path
C) Block size of the backup job
D) Buffer size of the network adapter on the host
3. The following message appears on the D2D StoreOnce system at the customer site:
The RAID has failed catastrophically, no RAID devices are available
What is a possible reason for this error?
A) There are two faulty disks within the RAID 6, and all data will be lost.
B) The HP Smart Array RAID Controller has failed and needs replacing.
C) The BIOS cannot find the boot loader and needs to be reset.
D) You have to change the boot order to boot from the USB stick.
4. A local retail company needs to replicate data between a current and a new HP StoreOnce device. What is the best method to seed the replicated data?
A) Tape Replication
B) Co-location
C) Remote Location
D) Low Bandwidth Replication
Solutions:
Question # 1 Answer: A | Question # 2 Answer: B | Question # 3 Answer: B | Question # 4 Answer: C |