HP BladeSystem Networking Sample Questions:
1. Two switches are connected together with six Ethernet cables. All six connections must be used in a link aggregation group (LAG) and contain standby links. How must the U\G be created'?
A) Statically from the passive switch
B) Dynamically from the active switch
C) Statically from the active switch
D) Dynamically from the passive switch
2. An HP BladeSystern c7000 enclosure with Virtual Connect Fibre Channel modules is located in a data center named DC1. The server blades use Fibre Channel over Ethernet (FCoE) to communicate with the storage systems. Another HP BladeSystern c7000 enclosure is located in a data center named DC2 Data in DC1 needs to replicate the data on a server blade in DC2.
How should the replication occur?
A) DC1 should be configured to connect directly to DC2
B) TheFCoE traffic should be encapsulated to IP before it is transferred between the data centers
C) TheFCoE traffic should be routed to DC2
D) A dedicated VLAN should be created between the data centers
3. An HP BladeSystem c7000 enclosure has Virtual Connect FlexFabric modules. Port 1 of the module was configured with a Fibre Channel SFP transceiver, but the Fibre Channel transceiver has been replaced with an Ethernet transceiver, and cabled to a network switch.
What step must be taken to use the Ethernet transceiver?
A) The SFP transceiver must be configured for Ethernet traffic.
B) The port must be reconfigured.
C) The module must be restarted.
D) The connected server blade must be restarted.
4. A server blade uses Virtual Connect FlexFabric modules and a single FlexFabric adapter.
What is the maximum number of FlexNICs that can be configured with this server blade?
A) 32
B) 8
C) 16
D) 24
5. What must be enabled on a Layer 3 switch to allow communication between VLANs?
A) Quality of Service
B) IP routing
C) Loopback adapter
D) Spanning Tree Protocol
Solutions:
Question # 1 Answer: A | Question # 2 Answer: B | Question # 3 Answer: B | Question # 4 Answer: C | Question # 5 Answer: B |