We're so confident of our products that we provide no hassle product exchange.
Cisco Maintaining Cisco Service Provider Routing Protocols (MSPRP） Sample Questions:
1. Which Cisco IOS Software feature should you enable to monitor IGP neighbor flaps?
A) control plane protection
B) NetFlow
C) adjacency change logging
D) IP SLA
E) route dampening
2. Which three statements correctly describe the BGP route-flap-dampening feature?
(Choose three)
A) When a penalty drops below the reuse limit or when the route has been dampened for more than the maximum suppress time, the route becomes valid again.
B) If a cumulative penalty exceeds the suppress limit, the route is dampened.
C) Each BGP route flap is penalized by adding 1000 penalty points to the penalty
D) The penalty reduction rate is determined by the reuse limit.
E) The penalty is gradually decreased after the route stops flapping. When the penalty reaches one half of the reuse limit, the route is removed from the BGP table.
3. Which Cisco IOS XR Software hierarchical Route Policy Language policy configuration uses the existing RPL policy "test"?
A) route-policy test apply test
B) route-policy new use policy test
C) route-policy new apply test
D) route-policy new use test
4. You want to filter certain prefixes that are advertised by the BGP neighbor of the neighboring autonomous system. Which command will filter prefixes that are advertised from the BGP neighbor 2.2.2.2? For filtering, use the already configured route map as123.
A) neighbor 2.2.2.2 route-map as123 out
B) neighbor 2.2.2.2 route-map as123
C) neighbor 2.2.2.2 route-map as123 in
D) neighbor 2.2.2.2 distribute-list as123 out
E) neighbor 2.2.2.2 distribute-list as123 in
F) neighbor 2.2.2.2 distribute-list as123
5. Refer to the exhibit
The Cisco IOS Software platform PE1 has interface GigabitEthernet port 0/0 connected to the Cisco IOS XR software platform PE4 interface GigabitEthernet 0/4/0/2. OSPF cannot establish an adjacency. What is a possible solution to the problem?
A) Change the interface configurations on both platforms to point network type
B) Adjust the Cisco lOS XR Software hello and dead times to match Cisco IOS software
C) Explicitly configure the Cisco lOS XR Software interface to be active OSPF interface
D) Configure OSPF on each platform to ignore the interface MTU
Solutions:
| Question # 1 Answer: C | Question # 2 Answer: A,B,C | Question # 3 Answer: C | Question # 4 Answer: C | Question # 5 Answer: B |
By Kent
